Watlow EZ-ZONE RMC Manual de usuario descargar pdf (Pagina 206)

Watlow EZ-ZONE

RMC Module • 203 • Chapter 7 Features

Subroutine Count

Subroutine Step

Jump Step

Jump Count

End Type

Control Mode Enable

Wait for Mode

Step Type

Step Number

Control Mode 1 to 4

Target Set Point Loop 1 to 4

Hours

Minutes

Seconds

Rate

Wait for Process Enable 1 to 4

Wait for Process 1 to 4

Wait State Event 1 to 4

Day of Week

Guaranteed Soak Enable 1 to 4

Event (Output State) 1 to 8

Proﬁle Action Request

Proﬁle Start

Ramping Type

Proﬁle Type

Guaranteed Soak Deviation 1 to 4

Guaranteed Soak Enable

Source Function A

Source Instance A

Source Zone A

Source Error A

Source Function B

Source Instance B

Source Zone B

Source Error B

Source Function C

Source Instance C

Source Zone C

Source Error C

Source Function D

Source Instance D

Source Zone D

Source Error D

Source Function E

Source Instance E

Source Zone E

Source Error E

Source Function F

Source Instance F

Source Zone F

Source Error F

Source Function G

Source Instance G

Source Zone G

Source Error G

Source Function H

Source Instance H

Source Zone H

Source Error H

Current Step

Current Subroutine Step

Step Type

Target Set Point Loop 1 to 4

Active Set Point Loop 1 to 4

Step Time Remaining

Jump Count Remaining

Produced Control Mode Loop 1 to 4

(used by control loop 1 to 4)

Produced SP (Active Set Point) 1 to 4

(used by control loop 1 to 4)

Proﬁle Event Out A to H (Event 1 to 8)

Proﬁling

End Step Type

Before creating proﬁles within any given loop, ensure that all

applicable proﬁle settings are made in the Proﬁle Menu of the

Setup Page. Settings made here are then made available to all

proﬁles. Also, each loop that is to use a proﬁle must ﬁrst be

enabled to do so in the Control Loop Menu of the Setup Page.

An End Step will end the profile and set the control modes and set points to match the End Type. The state

of up to 8 event outputs may be set or maintained. The event outputs will not be set off unless specifically

stated in this step. If a profile does not have an End Step, the profile continues until step 250, then stops and

maintains the last set points and control modes. In Subroutines, the End Step returns control back to the

next profile step following the call.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 235 236

Comentarios a estos manuales

Sin comentarios

Watlow EZ-ZONE RMC Manual de usuario Pagina 206

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Watlow EZ-ZONE RMC