Watlow EZ-ZONE RM Limit Module Rev C Manual de usuario Pagina 126
- Pagina / 127
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Watlow EZ-ZONE
®
RML Module • 123 • Appendix
Declaration of Conformity
CE DOC EZ-ZONE RM-09-13 Page 1 of 1
EZ Zone Series RM
WATLOW
an ISO 9001 approved facility since 1996.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following Series RM (Rail Mount) products:
Model Numbers:
RM
followed by additional letters or numbers describing use of
up to four module
options of various inputs and outputs or communications.
Classification: Temperature control, Installation Category II, Pollution degree 2
Voltage and Frequency:
SELV 24 to 28 V ac 50/60 Hz or dc
Power Consumption: RMA models 4 Watts, any other RM model 7 Watts
Environmental Rating: IP20
Meet the essential requirements of the following European Union Directives by using the relevant standards show
below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326
-
1
2006
Electrical equipment for measurement, control and laboratory use
–
EMC
requirements, Industrial Immunity, Class A Emissions (Not for use in a
Class B environment without additional filtering).
EN 61000-4-2 2008 Electrostatic Discharge Immunity
EN 61000-4-3 2010 Radiated Field Immunity
EN 61000-4-4 2011 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5 2006 Surge Immunity
EN 61000-4-6 2008 Conducted Immunity
EN 61000-4-11 2004 Voltage Dips, Short Interruptions and Voltage Variations Immunity
EN 61000-3-2 2005 Harmonic Current Emissions
EN 61000-3-3
1
2005 Voltage Fluctuations and Flicker
SEMI F47 2000 Specification for Semiconductor Sag Immunity Figure R1-1
1
NOTE: To comply with flicker requirements cycle time may need to be up to 160 seconds if load current
is at 15A, or the maximum source impedance needs to be < 0.13Ω
ΩΩ
Ω. Control power input of RM models
comply with 61000-3-3 requirements.
2006/95/EC Low-Voltage Directive
EN 61010
-
1
2010
Safety Requirements of electrical equipment for measurement, control and
laboratory use. Part 1: General requirements
Compliant with 2002/95/EC RoHS Directive
Per 2002/96/EC W.E.E.E Directive
Please Recycle Properly
Joe Millanes Winona, Minnesota, USA
Name of Authorized Representative Place of Issue
Director of Operations September 2013
Title of Authorized Representative Date of Issue
Signature of Authorized Representative
- User’s Guide 1
- RM Limit Module 1
- RM Limit Module 1
- Safety Information 2
- Warranty 2
- Technical Assistance 2
- Table of Contents 4
- Table of Contents (cont.) 5
- Chapter 1: Overview 6
- Introduction 7
- A Conceptual View of the RML 8
- • 6 • Chapter 1 Overview 9
- Module Orientation 10
- Getting Started Quickly 11
- Chapter 2: Install and Wire 14
- Dimensions 14
- Power Supplies 16
- Modular Backplane Connector 17
- Module Installation 17
- Removal of the Modular Back 18
- Module Removal 18
- Limit Module (RMLx-xxxx-xxxx) 19
- RML System Isolation Blocks 22
- Communications 23
- Low Power 23
- Inputs 1 through 12 RTD 24
- Digital Outputs 1 - 6 25
- Process Inputs 1 through 12 25
- DC90-60C0-0000 26
- RML Part # Digit 7, 8 is J 27
- RML Part # Digit 8 is B 27
- Quencharc Wiring Example 28
- Model 485TB-2W 29
- B B electronics 29
- EZKB-_A_ _-_ _ _ _ 30
- Power Supply 31
- Low Voltage 31
- Class 2 31
- Chapter 3: Operations Pages 34
- Chapter 4: Setup Pages 44
- Navigating the Setup Page 44
- [`Set] Timer Menu 45
- 0x86 (134) 54
- 0x83 (131) 58
- 0x82 (130) 60
- 0x7F (127) 62
- 0x66 (102) 74
- Chapter 5: Factory Pages 76
- Navigating the Factory Page 76
- Chapter 6: Features 81
- Calibration Offset 82
- Calibration 82
- Filter Time Constant 83
- Sensor Selection 83
- Scale High and Scale Low 83
- Temperature 84
- Alarm Silencing 85
- Alarm Blocking 85
- Lockout Menu 85
- Using Password Security 86
- • 84 • Chapter 6 Features 87
- Software Configuration 88
- • 86 • Chapter 6 Features 89
- • 87 • Chapter 6 Features 90
- Function Block Descriptions 91
- -1,999.000 to 9,999.000 92
- Input Error Latching 93
- Counter Function 95
- Custom Function 95
- Diagnostic Function 95
- Digital Input/Output Function 96
- Global Function 96
- Input Point 2 97
- Logic Function 98
- Watlow EZ-ZONE 100
- Math Function 101
- Overview 102
- Switch Over 103
- Multiply 104
- Absolute Difference 105
- Output Function 106
- Security Function 107
- Timer Function 108
- One Shot 111
- Retentive 112
- Variable 113
- Chapter 7: Appendix 114
- RML Specifications 120
- • 120 • Appendix 123
- Electrical Slope 80 124
- • 122 • Appendix 125
- EZ Zone Series RM 126
- How to Reach Us 127
Relacionado con productos y manuales para Sensores Watlow EZ-ZONE RM Limit Module Rev C
Sensores Watlow EZ-ZONE RMA Modul Manual de usuario
(79 paginas)
(79 paginas)
Sensores Watlow EZ-ZONE RMA Modul Manual de usuario
(79 paginas)
(79 paginas)
Sensores Watlow EZ-ZONE RM Manual de usuario
(155 paginas)
(155 paginas)
Sensores Watlow EZ-ZONE RMA Modul Manual de usuario
(80 paginas)
(80 paginas)
Sensores Watlow EZ-ZONE RMA Modul Manual de usuario
(79 paginas)
(79 paginas)
Sensores Watlow EZ-ZONE RMA Modul Manual de usuario
(79 paginas)
(79 paginas)
Sensores Watlow EZ-ZONE RMC Manual de usuario
(213 paginas)
(213 paginas)
Sensores Watlow EZ-ZONE RMC Manual de usuario
(213 paginas)
(213 paginas)
Sensores Watlow EZ-ZONE RMC Manual de usuario
(213 paginas)
(213 paginas)
Sensores Watlow EZ-ZONE RMC Manual de usuario
(236 paginas)
(236 paginas)
Sensores Watlow EZ-ZONE RME Manual de usuario
(112 paginas)
(112 paginas)
Sensores Watlow EZ-ZONE RME Manual de usuario
(24 paginas)
(24 paginas)
Sensores Watlow EZ-ZONE RME Manual de usuario
(124 paginas)
(124 paginas)
Sensores Watlow EZ-ZONE RMC Manual de usuario
(213 paginas)
(213 paginas)
Sensores Watlow EZ-ZONE RME Manual de usuario
(113 paginas)
(113 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.061 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales