Watlow MICRODIN Manual de usuario Pagina 52
- Pagina / 106
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Parameters
5.4 Watlow MicroDIN =Read Only; =Read/Write; =Turn On/Off
ON
Input Group – Monitor
Input Actual
• Monitor the input value.
• During an input error state, this will read 9999 if Read Control
Output (Control Output Group) is set to heat or -1999 if it is set to
cool.
• Read only
• Modbus: 100
Range
input type range
Default
none
Active
always
Input Error
• Monitor the input error status.
• Read only
• Modbus: 101
Range
0: no error
1: analog-to-digital signal under range
2: sensor under range
3: sensor over range
4: analog-to-digital over range
Default
none
Active
always
ç
CAUTION:
Avoid writing
continuously to
EEPROM memory.
Continuous writes
may result in
premature control
failure, system
downtime and
damage to
processes and
equipment.
See Disable Non-
volatile Memory
(System Group).
Input Group
Monitor
Input Actual ............................................... 5.4
Input Error ................................................ 5.4
Setup
Sensor Type ............................................... 5.5
Input Type ................................................. 5.5
Range Low ................................................. 5.6
Range High ................................................ 5.6
Calibration Offset ...................................... 5.6
Filter Time Constant ................................ 5.7
Input Error Action ..................................... 5.7
- MICRODIN 1
- User’s Manual 1
- Addendum 2
- Declaration of Conformity 3
- Meet the MicroDIN Team 4
- Safety Information 5
- Technical Assistance 5
- Your Feedback 5
- Table of Contents 6
- Chapter One: 7
- Setup Steps 9
- Indicator Lights 9
- Overview 10
- Chapter Two: 11
- Communications Setup 11
- Communications Overview 12
- EIA-485 Network 13
- Communication 14
- MicroDIN, A Modbus 15
- Remote Terminal Unit (RTU) 15
- Modbus Register Numbers 16
- Set Address/Baud Rate 17
- C D D C 18
- 8 None 1 1 19
- Chapter Three: 21
- Installation and Wiring 21
- Introduction 22
- Mounting the MicroDIN 23
- Figure 3.3 23
- Install and Wire 24
- To Mount MicroDIN 24
- To Dismount MicroDIN 24
- Input Wiring 26
- Output and Power Wiring 27
- Communications Wiring 28
- Wiring Examples 30
- Chapter Four: 33
- Features 33
- The System 34
- Power Limit 35
- Calibration Offset 36
- Filter Time Constant 37
- Sensor Selection 38
- Range Low and Range High 38
- Control Methods 39
- Proportional Control 40
- Alarm Set Points 43
- Alarm Hysteresis 43
- Process or Deviation Alarms 44
- Alarm Latching 44
- Alarm Silencing 45
- Panel Indicator Lights 46
- Open Loop Detect 46
- Bumpless Transfer 47
- Chapter Five 49
- Learn the Parameters 49
- System Group 50
- System Group continued 51
- Input Group 52
- Input Group continued 53
- Control Output Group 56
- Parameters 57
- Power Limit Set Point 57
- High Side Power 57
- Low Side Power 58
- Fixed Manual Output 58
- Operation Group 59
- Operation Group continued 60
- PID Group 61
- PID Group continued 62
- Alarm Output Group continued 66
- Error Group continued 70
- Characteristics Group 73
- Serial Number 2 74
- Software ID Number 74
- Software Revision 74
- Diagnostics Group continued 75
- Calibration Group continued 78
- Chapter Six: 81
- Operation and Calibration 81
- MicroDIN Startup 82
- MicroDIN Shutdown 83
- Operations 84
- • See p. 5.6 85
- Equipment Required 86
- Setup and calibration 86
- Appendix 87
- Writing a Modbus Application 88
- Packet Syntax 88
- Loop Back Command (0x08) 91
- Exception Responses 92
- Glossary 94
- Output #1: User selectable 99
- Output #2: User selectable 99
- A.14 Watlow MicroDIN 100
- Ordering Information 101
- 4.4, 5.6 102
- Watlow MicroDIN A.17 103
- Parameter Index 104
- Statement: 106
- Quality and 106
Relacionado con productos y manuales para Sensores Watlow MICRODIN
Sensores Watlow MINICHEF 2000 Manual de usuario
(71 paginas)
(71 paginas)
Sensores Watlow LogicPro Manual de usuario
(296 paginas)
(296 paginas)
Sensores Watlow MLS Manual de usuario
(142 paginas)
(142 paginas)
Sensores Watlow NAFEM Gateway Manual de usuario
(51 paginas)
(51 paginas)
Sensores Watlow Power Series Rev H Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(28 paginas)
(28 paginas)
Sensores Watlow Power Series Manual de usuario
(28 paginas)
(28 paginas)
Sensores Watlow Power Series Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(28 paginas)
(28 paginas)
Sensores Watlow QPAC Manual de usuario
(34 paginas)
(34 paginas)
Sensores Watlow SBL Card Manual de usuario
(2 paginas)
(2 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales