Watlow MICRODIN Manual de usuario Pagina 25
- Pagina / 106
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Watlow MicroDIN 3.5
Install and Wire
MicroDIN RJ-11 and 10-pin Connectors
The MicroDIN 10-pin screw terminal connector, on the bottom of the case, links
it to its power supply, control input, control output and alarm output. Use 26- to
14-gauge wire to connect to the plug terminals.
The alarm output is an electromechanical relay.
See the Appendix for information on sensor ranges and specifications. See
Chapter 5
: Parameters for information about software configuration.
1 2345678910
Input
1. S1 or thermocouple+
2. S3 or thermocouple-
3. S2
Control Output
4. dc+
5. dc-
6. common (COM)
Alarm Output (electromechanical relay)
7. alarm normally open (NO)
8. alarm common (COM)
Power
9. L2, 24V‡ (ac/dc)-
10. L1, 24V‡ (ac/dc)+
Figure 3.5 - Bottom view
of MicroDIN case with
connector assignments.
communications
sockets 1 and 2
(RJ-11)
12345678910
10-pin removable connector
Front of Unit
Ó
WARNING:
To avoid potential
electric shock, use
National Electric Code
(NEC) safety practices
when wiring and
connecting this unit to a
power source and to
electrical sensors or
peripheral devices.
Failure to do so could
result in injury or death.
ç
WARNING:
Install high or low
temperature limit control
protection in systems
where an over
temperature fault
condition could present a
fire hazard or other
hazard. Failure to install
temperature limit control
protection where a
potential hazard exists
could result in damage to
equipment and property
and injury to personnel.
Bottom View
ABCD
- MICRODIN 1
- User’s Manual 1
- Addendum 2
- Declaration of Conformity 3
- Meet the MicroDIN Team 4
- Safety Information 5
- Technical Assistance 5
- Your Feedback 5
- Table of Contents 6
- Chapter One: 7
- Setup Steps 9
- Indicator Lights 9
- Overview 10
- Chapter Two: 11
- Communications Setup 11
- Communications Overview 12
- EIA-485 Network 13
- Communication 14
- MicroDIN, A Modbus 15
- Remote Terminal Unit (RTU) 15
- Modbus Register Numbers 16
- Set Address/Baud Rate 17
- C D D C 18
- 8 None 1 1 19
- Chapter Three: 21
- Installation and Wiring 21
- Introduction 22
- Mounting the MicroDIN 23
- Figure 3.3 23
- Install and Wire 24
- To Mount MicroDIN 24
- To Dismount MicroDIN 24
- Input Wiring 26
- Output and Power Wiring 27
- Communications Wiring 28
- Wiring Examples 30
- Chapter Four: 33
- Features 33
- The System 34
- Power Limit 35
- Calibration Offset 36
- Filter Time Constant 37
- Sensor Selection 38
- Range Low and Range High 38
- Control Methods 39
- Proportional Control 40
- Alarm Set Points 43
- Alarm Hysteresis 43
- Process or Deviation Alarms 44
- Alarm Latching 44
- Alarm Silencing 45
- Panel Indicator Lights 46
- Open Loop Detect 46
- Bumpless Transfer 47
- Chapter Five 49
- Learn the Parameters 49
- System Group 50
- System Group continued 51
- Input Group 52
- Input Group continued 53
- Control Output Group 56
- Parameters 57
- Power Limit Set Point 57
- High Side Power 57
- Low Side Power 58
- Fixed Manual Output 58
- Operation Group 59
- Operation Group continued 60
- PID Group 61
- PID Group continued 62
- Alarm Output Group continued 66
- Error Group continued 70
- Characteristics Group 73
- Serial Number 2 74
- Software ID Number 74
- Software Revision 74
- Diagnostics Group continued 75
- Calibration Group continued 78
- Chapter Six: 81
- Operation and Calibration 81
- MicroDIN Startup 82
- MicroDIN Shutdown 83
- Operations 84
- • See p. 5.6 85
- Equipment Required 86
- Setup and calibration 86
- Appendix 87
- Writing a Modbus Application 88
- Packet Syntax 88
- Loop Back Command (0x08) 91
- Exception Responses 92
- Glossary 94
- Output #1: User selectable 99
- Output #2: User selectable 99
- A.14 Watlow MicroDIN 100
- Ordering Information 101
- 4.4, 5.6 102
- Watlow MicroDIN A.17 103
- Parameter Index 104
- Statement: 106
- Quality and 106
Relacionado con productos y manuales para Sensores Watlow MICRODIN
Sensores Watlow MINICHEF 2000 Manual de usuario
(71 paginas)
(71 paginas)
Sensores Watlow LogicPro Manual de usuario
(296 paginas)
(296 paginas)
Sensores Watlow MLS Manual de usuario
(142 paginas)
(142 paginas)
Sensores Watlow NAFEM Gateway Manual de usuario
(51 paginas)
(51 paginas)
Sensores Watlow Power Series Rev H Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(28 paginas)
(28 paginas)
Sensores Watlow Power Series Manual de usuario
(28 paginas)
(28 paginas)
Sensores Watlow Power Series Manual de usuario
(72 paginas)
(72 paginas)
Sensores Watlow Power Series Manual de usuario
(28 paginas)
(28 paginas)
Sensores Watlow QPAC Manual de usuario
(34 paginas)
(34 paginas)
Sensores Watlow SBL Card Manual de usuario
(2 paginas)
(2 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.033 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales