Watlow MINICHEF Deep Fat Fryer Application Manual de usuario Pagina 91

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 111
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 90
Application 18 Watlow MiniChef 2000 89
play and an audible tone will sound for 2 seconds. Then [`idle] will appear on the
display. If Real Time Clock option is installed and [setUp] / [Cloc`] is set to
[``yes], the time of day will appear on the display.
Preheat
If in the Configuration Mode [SEtUP] / [ready]] has been set to yes, the controller will
detect temperatures and preheat to operating temperature (above relative set point
minus the ready band) as required.
Activate the menu by pressing the Start/Stop key.
If the fryer is not at operating temperature, it will preheat. Meanwhile:
The word [pre-`] [`Heat] will appear on the display for a few moments. The
Start/Stop key indicator light will flash slowly. The temperature of Channel 1 will
be displayed until the operating temperature is reached.
The heat output indicator light – G, just below the display – will light up whenever
the controller is calling for heat.
When the fryer is at operating temperature (above relative set point minus the
ready band) [ready] will appear on the display and the Start/Stop key indicator
light will flash rapidly. You are now ready to cook with the active menu.
If the fryer is at operating temperature, the display goes directly to [ready] with-
out indicating preheat or temperature.
The Melt Cycle
To avoid burning, congealed oil requires a slow heating action. If in the Configuration
Mode, [etype] / [melt] has been set to on, when the oil temperature is below 212°F
the heat output will be limited to 10% of full power.
Run a Menu (with preheat feature)
This procedure describes how to run an active menu when the preheat feature is active
— in other words, when the [ready] parameter in the [SetUp] function of the
Configuration Mode is set to [yes``].
1. Select the menu you want to run as shown earlier in “Select a Menu”.
2. With [`idle] or time of day on the display, press the Start/Stop key.
AB
DE
C
F
GH
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
SLOW
FLASH
AT OPERATING TEMPERATURE
(PREHEAT CONDITION MET)
RAPID
FLASH
B
DE
C
F
MINICHEF 2000
[100f`]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[ready]
Edit Accept
Back-UpExit
G H GH
A A
[pre-`] [`Heat]
Vista de pagina 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 110 111

Comentarios a estos manuales

Sin comentarios