Watlow MINICHEF Deep Fat Fryer Application Manual de usuario descargar pdf (Pagina 88)

86 ■ Watlow MiniChef 2000 Application 18

Program Mode Quick Reference

These are the functions, parameters and values included in the Program Mode for this

application. You must select Application 18 to access them. For menu programming

directions, see the Hardware & Software Setup Guide. The Appendix of that guide

includes a detailed explanation of all parameters and values.

Function Parameter Value Your Settings

[M`__] Menu Numbers 1 - 6 [Stpt1] Set point 1 Temperature range low

Temperature of set point 1. to range high.

[TiNe1] Time 1 Format varies based

Run time of set point. on configuration.

[alarn] Mid-menu Stir, Add, Flip, Turn, Alert,

Alarm None.

[atiNe] Mid-menu 0 to [TiNe1].

alarm time.

Auto-tuning Note:

Before auto-tuning Application 18, Set Point 1 of Menu 1 must first be set to a value

that is typical of your application. (See Hardware & Software Setup Guide for informa-

tion on programming menus.) Then set [tHerl] / [tunE1] to [```on]. After you

accept [```on], by pressing “Enter,” the controller will display [`tunE] while auto-

tuning is taking place.

The controller will cancel the auto-tuning process if it cannot be completed in 80 min-

utes. You can cancel the auto-tuning process at any time by pressing either key C or key

D and accepting [``Off], by pressing “Enter,” when it appears.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 110 111

Sin comentarios

Watlow MINICHEF Deep Fat Fryer Application Manual de usuario Pagina 88