
Step 1 Install the Controller
Step 1 Install the Controller
• Select sheet metal (16-, 18-, 20- or 22- gauge panel).
• For panel knock-out patterns, see subsequent pages of this guide.
• Use #6-32 mounting studs x 0.50” length minimum, either pressed or welded.
• Install the unit with either a horizontal or vertical mounting collar position.
• Install mating connectors to unit.
Note: This device should be used in systems that incorporate a separate high limit device for safety.
Figure 8 — Mounting the MINICHEF 2000.
Mounting Collar
in horizontal position
Panel showing recommended knock-out pattern
MINICHEF 2000 Controller
8 ■ Watlow MINICHEF 2000 Hardware & Software Setup Guide
Comentarios a estos manuales