Watlow MINICHEF 2000 Manual de usuario descargar pdf (Pagina 17)

Step 2 Wire the Controller

16 ■ Watlow MINIC HEF 2000 Hardware & Software Setup Guide

Event Output 1 and Event Output 2

Note: The following illustrations are views of the back of the controller, not of the mating connector.

F 2 _ _ - _ _ _ 1 - _ _ _ _ (switched dc, 5V nominal, 30mA, non-isolated outputs)

Figure 16a — Event Outputs.

Warning: If event outputs 1 & 2 are used to cause or initiate machine motion, appropriate reasonable care should be

taken to prevent personal injury or machine damage as a result of machine motion.

Note: Not all software applications require event outputs 1 & 2. For specific information consult the application

guide for the application you are using.

Output 5: Audible Alarm Output Signal Option

Note: The following illustrations are views of the back of the controller, not of the mating connector.

Alarm signal available at connector, 5V nominal, 30ma, non-isolated.

F 2 _ _ - _ _ _ _ - _ 0 _ _ (unit without internal audible alarm)

Figure 16c — Switched DC.

Note: Pin 5 is shared with event output 2 wiring.

123

4 5 6

789

10 11 12

13 14 15

Ext. Load

4 56

789

10 11 12

13 14 15

Ext. Load

Event Output 2

456

789

10 11 12

13 14 15

Ext. Load

Event Output 1

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 70 71

Sin comentarios

Watlow MINICHEF 2000 Manual de usuario Pagina 17