Watlow Series F4S/D Manual de usuario descargar pdf (Pagina 18)

3.2 ■ Operations Watlow Series F4S/D

ç WARNING

Check the configuration of the controller on the Setup

Page before starting and running a profile (if the Setup

Page is not locked). Make sure the settings are appropri-

ate to the profile: input sensor ranges and limits, digital

inputs and outputs as events, guaranteed soak band, re-

sponse to power out and Celsius or Fahrenheit scales. If

the Setup Page is accessible, failure to check the configu-

ration before running a profile could result in damage to

equipment and/or property, and/or injury or death to per-

sonnel.

Profile Control π

The main purpose of the Series F4 is to control pro-

files for ramp-and-soak-processing applications.

The instructions below explain how to use an exist-

ing profile. To program a profile, see Chapter 4,

Profile Programming.

Start a Profile? ■

■

▼ No ▲ Yes ■

■■■■■■■■■■■■■■■■

To Start/Run a Profile

To initiate the profile mode, press the Profile Key

π and answer the questions that follow.

While running a profile, the Profile Status message

on the lower display will keep you informed about

the progress of the profile. For example, it could

read like the screen at right:

✔

NOTE:

As a protective measure, all stored profiles will be cleared

if you enter the Setup Page and change values in the

Analog Input 1, 2, 3 menus —specifically, the Sensor,

Sensor Type, Decimal, Scale (for process inputs), and Set

Point High and Low Limits. Pop-up messages will warn

that the profiles will be erased from the controller’s mem-

ory.

✔

NOTE:

You must configure the software for your inputs and out-

puts before programming a profile. See the Setup Chap-

ter.

✔

NOTE:

You must program a profile or use the pre-programmed

MILSTD810D profile before running it. See the Profile

Programming Chapter.

✔

NOTE:

While a profile is running, the controller will not recog-

nize digital inputs that are programmed to start a profile.

Such digital inputs will be recognized only while the con-

troller is in the static set point mode.

✔

NOTE:

While a profile is running, profiles can be either created

or renamed only while a profile is running. All other

pages and menus can be entered only during Static Set

Point Control mode.

Glaze 8 Running.

Step 2

Remain 00:10:30

Start:_______________

Step 1 Autostart

>Step 2 Ramp Time

Step 3 Ramp Time

Start Profile:_______

MILSTD810D..........

ALUMINUM

>Glaze 8

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 151 152

Comentarios a estos manuales

Sin comentarios

Watlow Series F4S/D Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Watlow Series F4S/D