Watlow EZ-ZONE ST Manual de usuario descargar pdf (Pagina 16)

Watlow EZ-ZONE

®

ST • 14 • Chapter 2 Install and Wire

Mounting and Dismounting the Controller from a DIN Rail

To mount the controller on a DIN rail, first

hook the top flange on the back of the heat

sink on to the top of the DIN rail. Then

rotate the controller to an upright position

until the lower flange snaps into place.

To dismount the controller, first use a

screwdriver to pull down the small le-

ver on the bottom of the heat sink and

rotate the bottom of the controller for-

ward. Then lift the the controller off of

the rail.

Note:

Typically, the DIN rail is mounted before com-

ponents are mounted on it.

Installation

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 96 97

Comentarios a estos manuales

Sin comentarios