Watlow Addendum to EZwarePlus Manual de usuario descargar pdf (Pagina 43)

11) Click OK to close the Address dialog

12) For Mode choose External Trigger.

13) For Trigger address PLC name choose the OIT (Local HMI by default).

14) For Trigger address Device type choose LB to use an internal bit to cause the OIT to store

values in a recipe.

15) In Trigger address Address type 500.

16) Click the Label tab.

17) Check Use label.

18) Set State to 0.

19) In Content type the name of the parameter.

20) Click OK.

21) Place the Data Transfer (Trigger-based) object on the screen.

Repeat the following steps to create the data transfer items that will load recipes in to the

controller:

Note: For the data transfer objects that load the recipe from the OIT to the controller, the source

addresses are RW (recipe words) addresses in the OIT and the destination addresses are the parameters’

Modbus addresses in the controller.

Parameter

“Source”

Recipe

Address

Size in

Words

“Destination” Address in Controller

RMC

RMH

ST GTW*

Closed Loop Set Point

2501

5221

2161

Alarm High Set Point

1741

2661

1481

Heat Proportional Band

2231

4111

1891

233

1897

Integral

2235

4115

1895

227

1891

Derivative

2237

4117

1897

229

1893

*ST via RUI Gateway

Silver Series EM OIT  43  Watlow Addendum

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49 50

Comentarios a estos manuales

Sin comentarios

Watlow Addendum to EZwarePlus Manual de usuario Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Watlow Addendum to EZwarePlus