Watlow Addendum to EZwarePlus Manual de usuario descargar pdf (Pagina 23)

Add an Option List for Control Mode

This example assumes you have created a window in a project that communicates with a Watlow

Controller and that window is open in EZwarePlus.

1) On the Objects menu,

click Button then

choose Option List.

2) Click the General tab.

3) In Comment type

Control Mode.

4) Set Mode to Drop-

down list.

5) Set Item No. to 3.

6) In the Monitor

address group:

• For PLC name choose

Modbus RTU Master or

Modbus TCP/IP

Master.

• Click Setting…

• For Device type choose

4x.

• In Address enter the

address of the Control

Mode. See the table.

• Select the data type in

the field below the

Address field.

• Click OK to close the

Address dialog

7) Click the Mapping

tab.

(019)

For this controller…

This

parameter…

Enter this

Address*…

Choose this

Data Type…

RMCxxxx-xxxxxxx

Control Mode

2221

16-bit Unsigned

RMHx-xxxx-x1xx

4101

16-bit Unsigned

PMxxxxx-xxxxxxx

1881

16-bit Unsigned

STxx-xxMx-xxxx

222

16-bit Unsigned

ST via RUI Gateway

1881

16-bit Unsigned

Other Controllers

Consult the controller manual.

*These addresses have already been changed to the absolute form required

for EZwarePlus by adding 1 to the value listed in the Watlow manual. Enter

them as listed.

Silver Series EM OIT  23  Watlow Addendum

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 49 50

Comentarios a estos manuales

Sin comentarios

Watlow Addendum to EZwarePlus Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Watlow Addendum to EZwarePlus