Watlow Series 734 Data Communications Manual de usuario descargar pdf (Pagina 8)

How to Use Data Communications

WATLOW Series 733/734

Prompt This Range Factory Appears…

Value Default

[bAUd][bAUd]

[bAUd] (Baud rate)

300, 600, 1200, 2400, 4800, 9600 1200 if comms unit

[dAtA][dAtA]

[dAtA] 7o = 7 data bits and odd parity

7E = 7 data bits and even parity

8n = 8 data bits and no parity 7o if comms unit

(Start bit = 1) (Fixed)

(Stop bit = 1) (Fixed)

[Prot][Prot]

[Prot] FULL = ANSI X3.28 2.2 - A.3 FULL if comms unit

On = XON - XOFF

[Addr][Addr]

[Addr] 0 to 31 (ASCII) 0 if Prot = FULL

Program Mode - Communications Prompts

Enter the Program Mode at the front panel: [0)º0]

Press key sequence:

The display shows: [C_F`]

Continue pressing:

Until: [bAUd]

Current value displays alternately: [1200] or [bAUd]

Press to change value: or

Press for next prompt:

Press to exit:

Document any changes.

Enter data on a photocopy of this page.

Comms Setup

Table 1 -

Program Mode

prompts and De-

scriptions.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Sin comentarios

Watlow Series 734 Data Communications Manual de usuario Pagina 8